The Arduino 4 Relays Shield allows your Arduino driving high power loads.
- Single pole chargeover contact maximum current @ 30 V DC 2A
- Maximum load voltage 48 V
- Maximum switching capacity 60 W
The Arduino 4 Relays Shield is a solution for driving high power loads that
cannot be controlled by Arduino's digital IOs, due to the current and voltage
limits of the controller. The Shield features four relays, each relay provides 2
pole changeover contacts (NO and NC); in order to increase the current limit of
each output the 2 changeover contacts have been put in parallel. Four LEDs
indicate the on/off state of each relay.
Features
Thinker Kit interface: 2x TWI, 2x OUT, 2x IN
Interfaces with Arduino Board: DIO
Relays: 4 (60W)
General
Operating Voltage 5 V
Current needs 140 mA (with all releays on, about 35 mA each)
PCB Size 53 x 68.5 mm