145188
Varen er på lager.
Varen er bestilt fra leverandør og leveringsdato er bekreftet.
Varen er bestilt fra leverandør, men leveringsdato er ikke bekreftet.
Varen må bestilles fra leverandør.
Varen befinner seg på fjernlager.
Varen er bestilt fra leverandør, men leveringsdato er ikke bekreftet.
Varene bestilles fra vår leverandørs lager.
Ubekreftet - Ta kontakt med kundesenter for nærmere informasjon.

 Handlevogn

Handlevognen er tom.
 


Nyhetsmail

Motta nyheter per epost.

13.56MHz RFID/NFC Card - 1KB

blank 13.56MHz RFID/NFC card

Oslo
10
Varenr:
139445
Lev.Produktnr.:
359
Netto: 59,-
 ink. mva.

Netto: 47,-   eks. mva.

Kjøp

139445  359 13.56MHz RFID/NFC Card - 1KB blank 13.56MHz RFID/NFC card
139445  359 13.56MHz RFID/NFC Card - 1KB blank 13.56MHz RFID/NFC card

Lenker: Produkt | Produsent | Support
  • DESCRIPTION

    This is a blank 13.56MHz RFID/NFC card - often used for train/bus passes but also found in other systems where a proximity card is desired. The tag contains a small RFID chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.

    These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle ISO/IEC 14443 Type A cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!

    These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.

    These use a ISO/IEC 14443 Type A chipset, which used to be the 'classic' NFC chipset. In ~2014, the NFC forum decided not to support this chipset anymore, so newer phones do not support it. This only matters if you're trying to use this tag with a phone/tablet.

  • TECHNICAL DETAILS

    RFID chip specification:

    • 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
    • Built in encryption engine with 48-bit key
    • 4 Byte unique identifier burned into the chip
    • 13.56 MHz frequency

    Tag specification:

    • 85.5mm x 54mm x 1mm /3.36" x 2.1" x 0.03"
    • 6.3 grams / 0.2 oz
    • Works about 4" away from reader


Copyright © 2017 Digital Impuls Oslo AS - All rights reserved
Forretningssystem og netthandel er levert av MultiCase™ Norge AS

(3.16.10.19)