SunFounder RAB Holder Kit

Breadboard, kabler, LED og motstandere

Varenr: 143274
Alt. varenr: SF_RABKIT
249,-
-+
0 stk. på lager i butikk og på nett
BeskrivelseTilbehørAlternativer
Beskrivelse

This RAB Holder is large enough for a Raspberry Pi, an Uno or Mega 2560, and a breadboard, convenient for making projects.

 This 830-tie/point breadboard includes an IC area of 630 points, plus two 100-point distribution strips, providing 4 power rails.

 With male-to-male jumper wires in different colors

  Size: 200 x 135 mm (7.87 x 5.31 inch)

  Comes with red, green, and yellow LEDs (two for each color), and six 1kO resistors.

Introduction

This RAB Holder Kit provides you all the necessary components for a simple experiment, including a breadboard, quite a lot of jumper wires, an RAB holder, six LEDs, and six 1K current-limiting resistors, thus you can start the experiment right away.

With this kit, you can fix for Arduino board, Raspberry Pi, and breadboard on the RAB Holder, free of careless short circuits on a metal desk or caused by some metal parts underneath. What’s more, it also comes with 65pcs jumper wires with different length in various colors, therefore, you can just plug them into the control board and breadboard to build circuits, no bothering about complicated soldering.

 

Package Contents:

1 x RAB Holder

1 x 830-Point Breadboard

65 x Jumper Wire

6 x 1kO Resistor

6 x LED (2 red, 2 yellow, and 2 green)

Several Screws

Tilbehør
Alternativer
Varen er på lager.
Varen er bestilt fra leverandør og leveringsdato er bekreftet.
Varen er bestilt fra leverandør, men leveringsdato er ikke bekreftet.
Varen må bestilles fra leverandør.
Varen befinner seg på fjernlager.
Varen er bestilt fra leverandør, men leveringsdato er ikke bekreftet.
Varene bestilles fra vår leverandørs lager.
Ubekreftet - Ta kontakt med kundesenter for nærmere informasjon.